Contact Us
  • Madas gear gas pressure regulator 1" model FRG/2MBCZ
  • Madas gear gas pressure regulator 1" model FRG/2MBCZ

Madas gear gas pressure regulator 1" model FRG/2MBCZ

  • Maximum working pressure of shut-off (mBar): equivalent to 20~70
  • Minimum working pressure of shut-off (mBar): equivalent to 7~20
  • Inlet pressure (Bar): equivalent to 5
  • Output pressure range (mBar): equivalent to 110 ~ 200
  • Operating temperature range: -20 ~ 60 degrees Celsius
$20
Tax excluded
Quantity

0
New
View all products of ماداس (MADAS)

Guide to choosing and buying Madas gear gas pressure regulator 1" model FRG/2MBCZ

Madas gas pressure regulator 1" model FRG/2MBCZ is a gear type and is used to adjust the output pressure in the burner and boiler.

According to the size of this model, its capacity is 25 m3/Hr.

It can be said that the most important task of these products is to convert the input pressure to the allowed output pressure, therefore the above regulators can reduce the maximum input pressure of 5 bar to the minimum output pressure, i.e. 0.5 bar.

These regulators have a filter and their difference from the RG series is having a filter on the device itself.

In general, Madas gas regulators are used to convert and adjust the input pressure to the permissible and appropriate output pressure for the system.

These products can be used in domestic and industrial gas installations where natural gas (dry gases) flow, and it is not suitable for working with LPG and the like.

Madas gas regulator frg/2mbcz

Features of Madas gear gas regulator size "1 FRG/2MBCZ model 

  • It has a shut-off valve when the output pressure exceeds the permissible limit or the output pressure is cut off.
  • It has a safety valve that increases the functionality and safety of the regulator.
  • Ability to work in the temperature range of -20 to +60 degrees Celsius
  • The inlet pressure in these gas regulators is 5 bar (equivalent to 75 pounds).
  • Also, the output pressure of these devices is 110 to 200 millibars.
  • It should be noted that each bar is equal to 15 pounds and each pound is equal to 75 millibars.
  • The closing time of the safety lock in this model is less than 1 second.
  • made in Italy


Tips for installing and using Madas gear gas regulator size "1 FRG/2MBCZ model

These products must be installed and operated by experienced people.

In case of failure of any of the technical parts of Madas gas pressure regulators, the part in question must be supplied by the authorized representative of this product, otherwise, the entire device will be voided from the warranty.

These products should only be used for the purpose for which they were made, otherwise, Madas will not accept responsibility for any damage.

The various components of the system are as follows

1 - Seismic joints

2 - Ball valve

3 - FRG/2MBCZ regulator filter, which is the distinguishing feature of this model from the RG series

4 - Ball valve

5 - Vent Valve

6 - Safety valve

7 - Low-pressure gauge equipped with a safety button

8 - High pressure measuring gauge equipped with a safety button

The correct method of installing gas regulator Madas gear 1" FRG/2MBCZ model

Conditions for resetting Madas gear gas regulator size "1 FRG/2MBCZ model

  • Make sure that all valves and valves before the regulator are closed.
  • Loosen the regulator cap.
  • Press the reset pin, wait a few moments for the pressure to reach the required balance, and then press the reset pin.
  • While holding the reset pin, open the ball valve before the regulator.
  • At this point, release the reset pin slowly and pull it down, making sure it doesn't touch the center pin.
  • In the last step, put the cap in place and close it tightly.

Important and necessary points before the initial start-up (First start), Madas gear gas regulator size 1" model FRG/2MBCZ

  • All the installation tips must be observed before the initial start.
  • The regulator and shut-off ducts must be free of any dust.
  • The pipe leakage test should be done without the regulator diaphragm.
  • The pressure test of the equipment should be done slowly to avoid possible damage to the equipment.
  • Close the ball valve before the regulator and open the safety valve slowly.
  • Open the shutter slowly.
  • Close the outlet manual valve.
  • Reset the device.
  • After closing the valve before the regulator and checking the strength of all equipment including the safety valve, open the shut-off again slowly and check the operation of the regulator after starting.

Madas gear gas regulator

Dimensions of Madas gear gas pressure regulator 1" model FRG/2MBCZ

Dimensions of Madas gear gas regulator size 1" FRG/2MBCZ model

Guarantee and originality of Madas gear gas pressure regulator 1" model FRG/2MBCZ

Damatajhiz company confirms the physical health and authenticity of the above gas regulators.
On the reference site and store of Damatajhiz, the possibility of buying Madas gas regulator (MADAS) with a guaranteed price and original warranty is provided for you, dear customers, in order to create a good feeling of optimal and smart shopping.

لیست نظرات

Shopping Cart

Cart is empty.

 

Account

Account

Menu
No account?
Create an Account
Contact Us