-
Account
-
Shopping Cart
Cart is empty.
- Out-of-Stock
Shokouh Gas Atmospheric Relay Model G100
- Application: Control of gas-fired atmospheric burners
- With a fireproof and unbreakable polycarbonate frame
- Has RESET button and help LED
- Input voltage: 220 volts
- Made in Iran
Guide to purchasing Shokouh Gas Atmospheric Relay-G100
Shokouh Electronic Company is one of the successful manufacturers of monitoring and automation control equipment, including atmospheric relays, which produces quality products in line with the highest quality assurance standards, relying on modern European technical knowledge, experienced specialists, as well as advanced machinery and equipment.
Shokouh Atmospheric Gas Relay Model G100 is a device for controlling gas-fired atmospheric burners with a fireproof and unbreakable polycarbonate frame with high safety. This controller is fully electronic and has a RESET button and a guide and screw LED located at the top of the relay.
Important points in using Shokouh Gas Atmospheric Relay Model G100
- Check the wiring before use. Defects or errors in wiring and wiring can be problematic and dangerous and cause irreparable damage. Note that the wiring may need to be changed if the G100 controller relay replaces another relay (other than the G100).
- When operating the controller, the connection screw must be tightened to ensure that the G100 controller is fully connected to the relay base.
- A suitable fuse is required in accordance with the technical specifications of the controller. In addition, the main fuse (s) must be selected in such a way that before the current reaches the nominal values in the technical specifications of the relay, operate and cut off the power. Otherwise, in the event of a short circuit in any part of the burner equipment, severe damage to the controller, burner parts or the user may occur.
- For safety reasons, each G100 controller must be turned off at least once every 24 hours.
- To install and/or remove the G100 controller relay, the main power switch must be disconnected and the burner must be disconnected from the power supply.
- The G100 controller relay is a precise electronic device with high safety and has been produced for the safety of the burner and its user system under the supervision of Shokouh Electronic Company specialists. Please refrain from opening or repairing it.
How the Shokouh Gas Atmospheric Relay Model G100 works
After the power is turned on, the spark and the throttle valve are given simultaneously, and after 7 seconds, the spark is stopped. The burner system is equipped with a pilot to prevent gas emissions if the flame is cut off for any reason.
Troubleshooting Shokouh Gas Atmospheric Relay Model G100
Problem 1: The torch does not start
solution:
- Check the power connection
- Check the status of the fuses
- The thermostat is OFF
- Gas pressure is OFF
- Check the wiring
Problem 2: The controller opens the fuel valve after starting and during the discharge time, but no flame is formed
solution:
- Check pin connections and wiring
Warranty conditions of Shokouh Gas Atmospheric Relay Model G100
Replacement, installation, and service must be performed by qualified and authorized personnel.
Conditions that cancel the relay warranty are:
- Lack of warranty card and floor sticker
- Burns, breakdowns, and deformations due to excessive heat exposure or over-voltage
- Severe mechanical shocks
- Open the frame or manipulate and repair the relay circuit
- Any improper wiring or error in the burner that burns part of the internal circuit of the relay
- Shokouh gas atmospheric relay model G100 has a 1-year warranty from the main company.
The originality of Shokouh Gas Atmospheric Relay Model G100
The company confirms the authenticity and physical health of Shokouh Gas Atmospheric Relay Model G100.
In the reference site and Damatajhiz store, all kinds of atmospheric relays have been provided for you, dear customers, in order to create a good feeling of optimal and smart purchase.