Shokouh dual-burner relay model TMG740

Guide to choosing and buying Shokouh dual-burner relay model TMG740

Shokouh Electronic Company is one of the successful manufacturers of monitoring and automation control equipment, including dual-burner relays, which, relying on modern European technical knowledge, experienced specialists, as well as advanced machinery and equipment, produces quality products in accordance with the highest quality assurance standards. . The TMG740 Shokouh Dual Burner Relay is designed to control large burners. This burner relay is designed to replace foreign products of the same name.

Technical specifications of Shokouh dual-burner relay model TMG740

• 220/240 V (-10… + 15%) 50Hz
• Frequency: 40 to 60 Hz
• Fuse type: 10 amps fast, 6 amps slow
• Power consumption: 5 volts amp
• The maximum current of each output is 2 amps and a total of 6 amps
• sensitivity:
  • Ion input: 1/6 µA
  • UV input: 70 µA
• Minimum sensor current:
  • 5µA - ION: Two LEDs
  • 250µA –UV: two LEDs
• Delayed restart: None
• Flame detection cables:
  • ION- maximum 50 meters of cable
  • UV - Maximum 100 meters of cable
• UV sensors:
  • UVZ780 red for high sensitivity
  • UVZ780 white for medium sensitivity
  • UVZ780 red for low sensitivity
• Approximate weight: 670 grams
• To install: Any direction
• Insulation standard: IP44
• Working temperature: 20-60 ° C

Technical characteristics of Shokouh TMG740 dual-burner relay

• Flame detection: The following types of flame detectors can be used:
  • Ionization electrode (switch in ION position), where the main power supply provides a neutral ground connection. Suitable for gas burners (spark has no effect on current signal)
  • Red UVZ780 type UV sensor (UV position switch) suitable for gas, dual burner and diesel burners
• considerations
  • If the ion rod burner connects to the body during operation, the controller goes into the fault phase.
  • If the GWRT (gas pressure and Hi-Lo thermostat) input is cut off at any stage, the system will go to stage one.
  • After the LED3 is lit until the spark is lit, if the flame is seen, the controller goes into the fault phase.
  • If this base is energized from another direction before opening the SV (main gas valve), the controller enters the fault phase, LED6 turns on, and LEDs 4 and 5 flash.
  • If the controller enters the fault phase, all outputs are disconnected and after 0.5 seconds the alarm base is established.
  • The error stage is displayed by LEDs 1 to 3 and the cause of the error is displayed by LEDs 4 and 5.
  • Note: The switch under the box should be adjusted according to the type of sensor connected.

The originality of Shokouh TMG740 dual-burner relay

The company confirms the authenticity and physical health of the glory dual-burner relay model TMG740.

In the reference site and Damatajhiz store, various types of dual-burner relays have been provided for you, dear customers, in order to create a good feeling of optimal and smart purchase.