-
Account
-
Shopping Cart
Cart is empty.
Shokouh dual-burner relay model TMG740
- Application: Gas burners and diesel burners
- Input voltage: 220 volts
- Frequency: 40 to 60 Hz
- Suitable working temperature: -20 to +60 degrees Celsius
- Install direction: Any direction
Guide to choosing and buying Shokouh dual-burner relay model TMG740
Shokouh Electronic Company is one of the successful manufacturers of monitoring and automation control equipment, including dual-burner relays, which, relying on modern European technical knowledge, experienced specialists, as well as advanced machinery and equipment, produces quality products in accordance with the highest quality assurance standards. . The TMG740 Shokouh Dual Burner Relay is designed to control large burners. This burner relay is designed to replace foreign products of the same name.
Technical specifications of Shokouh dual-burner relay model TMG740
- 220/240 V (-10… + 15%) 50Hz
- Frequency: 40 to 60 Hz
- Fuse type: 10 amps fast, 6 amps slow
- Power consumption: 5 volts amp
- The maximum current of each output is 2 amps and a total of 6 amps
- sensitivity:
- Ion input: 1/6 µA
- UV input: 70 µA
- Minimum sensor current:
- 5µA - ION: Two LEDs
- 250µA –UV: two LEDs
- Delayed restart: None
- Flame detection cables:
- ION- maximum 50 meters of cable
- UV - Maximum 100 meters of cable
- UV sensors:
- UVZ780 red for high sensitivity
- UVZ780 white for medium sensitivity
- UVZ780 red for low sensitivity
- Approximate weight: 670 grams
- To install: Any direction
- Insulation standard: IP44
- Working temperature: 20-60 ° C
Technical characteristics of Shokouh TMG740 dual-burner relay
- Flame detection: The following types of flame detectors can be used:
- Ionization electrode (switch in ION position), where the main power supply provides a neutral ground connection. Suitable for gas burners (spark has no effect on current signal)
- Red UVZ780 type UV sensor (UV position switch) suitable for gas, dual burner and diesel burners
- considerations
- If the ion rod burner connects to the body during operation, the controller goes into the fault phase.
- If the GWRT (gas pressure and Hi-Lo thermostat) input is cut off at any stage, the system will go to stage one.
- After the LED3 is lit until the spark is lit, if the flame is seen, the controller goes into the fault phase.
- If this base is energized from another direction before opening the SV (main gas valve), the controller enters the fault phase, LED6 turns on, and LEDs 4 and 5 flash.
- If the controller enters the fault phase, all outputs are disconnected and after 0.5 seconds the alarm base is established.
- The error stage is displayed by LEDs 1 to 3 and the cause of the error is displayed by LEDs 4 and 5.
- Note: The switch under the box should be adjusted according to the type of sensor connected.
The originality of Shokouh TMG740 dual-burner relay
The company confirms the authenticity and physical health of the glory dual-burner relay model TMG740.
In the reference site and Damatajhiz store, various types of dual-burner relays have been provided for you, dear customers, in order to create a good feeling of optimal and smart purchase.